Phosphorus, Elemental (alias of 1381)

CAS RN:7723-14-0

NFPA Hazard Classification

Phosphorus, amorphous
Phosphorus, white, molten

Phosphorus, amorphous

Flammability: 1
Health: 1Instability: 1
Special: None

Health: 1 (Slight)
Materials that, on exposure, would cause significant irritation, but only minor residual injury, including those requiring the use of an approved air-purifying respirator. These materials are only slightly hazardous to health and only breathing protection is needed.

Flammability: 1 (Slight)
This degree includes materials that must be preheated before ignition will occur, such as Class IIIB combustible liquids and solids and semi-solids whose flash point exceeds 200 deg F (93.4 deg C), as well as most ordinary combustible materials. Water may cause frothing if it sinks below the surface of the burning liquid and turns to steam. However, a water fog that is gently applied to the surface of the liquid will cause frothing that will extinguish the fire.

Instability: 1 (Slight)
This degree includes materials that are normally stable, but that may become unstable at elevated temperatures and pressures and materials that will react with water with some release of energy, but not violently. Fires involving these materials should be approached with caution.

top

Phosphorus, white, molten

Flammability: 4
Health: 4Instability: 2
Special: None

Health: 4 (Extreme)
Materials that, on very short exposure, could cause death or major residual injury, including those that are too dangerous to be approached without specialized protective equipment. A few whiffs of the vapor or gas can cause death, or contact with the vapor or liquid may be fatal, if it penetrates the fire fighter's normal protective gear. The normal full protective clothing and breathing apparatus available to the typical fire fighter will not provide adequate protection against inhalation or skin contact with these materials.

Flammability: 4 (Extreme)
This degree includes flammable gases, flammable cryogenic materials, pyrophoric liquids, and Class IA flammable liquids. The preferred method of fire attack is to stop the flow of material or to protect exposures while allowing the fire to burn itself out.

Instability: 2 (Moderate)
Materials that can undergo violent chemical changes at elevated temperatures and pressures. This also includes materials that may react violently with water or that may form potentially explosive mixtures with water. In advanced or massive fires involving these materials, fire fighting should be done from a safe distance or from a protected location.

top
Find more information on this substance at: Hazardous Substances Data Bank , TOXMAP , TOXNET , PubMed